13
To install the saw blade
(fig 4 & 5)
1. Detach the battery pack from the saw.
2. Rotate the quick-release knob clockwise until it stops;
this will release the drive wheel.
3. Match the direction of the arrow on the blade with to
the arrow on the pulleys, and then slip the blade into
the guide rollers, as shown in Figure 4.
4. Holding the blade in the guide rollers, place it around
both pulleys and through the material guide, as shown
in Figure 5.
5. Make sure that the blade is fully inserted into the guide
rollers and positioned squarely against the pulleys.
6. Rotate the quick-release knob counter-clockwise until
it stops to lock the blade in place. Make sure that the
teeth face away from the band saw.
7. Position the cover on the plate. Replace and tighten the
screws.
8. Make sure that the blade is properly seated on the
pulleys before starting the tool.
ASSEMBLY INSTRUCTIONS
WARNING!
• While making sure that the blade runs on the wheels properly, keep your body away from the blade area.
To Next Page
Loading...
Need help?
General