9
• Do not “jam” the blade or apply excessive pressure to the tool when cutting.
Overstressing the blade increases the loading and susceptibility to twisting or binding of the blade
in the cut and the possibility of blade breakage.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
................. Alternating current
............. Direct current
n
0
................... No-load speed
............... Class II Construction
…/min ........... Revolutions or reciprocation per minute
............... Grounding terminal
BPM ............... Beats per minute
SFPM .............. Surface feet per minute
.............. WARNING – To reduce the risk of injury, user must read instruction manual.
.............. WARNING – To reduce the risk of injury always wear eye protection.
.............. WARNING – To reduce the risk of injury always wear ear protection.
SAFETY GUIDELINES
To Next Page
Loading...