Features and Specs in this Owner’s Manual to determine
the location of bilge pump-out. Pump-outs should never be
obstructed.
Operation
The bilge system operates automatically, but can be manually
controlled by a digital switch in the accessory page of the left-
most screen on the dash or the dash switch panel. The manual
and automatic bilge discharge system is never completely OFF.
When in the automatic (default) position, a sensor alerts the
system to discharge water from the bilge area.
In the event that there appears to be excess water in the bilge,
the bilge pump can be manually activated by turning the bilge
pump switches to the ON position. Return the switch to the
automatic position when finished emptying the bilge. Leaving
the switch in manual mode can result in damage to the pump
and may not be covered by warranty!
Return the bilge switch to automatic any time it has been turned to
manual to remove water from the bilge. Operators should monitor
the water level through the floor access panel and ensure that the
bilge pump(s) does not continue to operate after the bilge is emptied.
Note that a small amount of water in the bilge is acceptable, except
when winterizing the bilge system. Failure to follow instructions
may result in damage to the bilge system, which may not be covered
under warranty!
To Next Page
Loading...
