Note that the underwater lights should never be operated
unless the boat is in the water. Even though these are LED
lights, they generate some heat and require the cooling effect
of the water to avoid prematurely burning out the bulbs.
Underwater lights may have thermal protection circuitry that will
turn the light off when reaching high temperatures. Allow lights
to cool in water in order to turn back on.
Troubleshooting
If lights do not operate, check the main circuit breaker panel to
determine if a circuit may have tripped. Reset the circuit; if it
continues to trip, take the boat to an authorized Aviara dealer.
If the circuit breaker has not tripped, the bulb may have burned
out. Although the lights are LEDs, which rarely burn out, it is
possible. Take the boat to an authorized Aviara dealer to have the
bulb replaced.
storage lights can be found on the 11” dash screen under the
lighting tab. The Accent switch will turn on all accent lighted
features, including the cupholders, speakers, etc. The Courtesy
switch will turn on walkway lighting. The Hardtop switch will
turn on the overhead hard top lights. The Underwater switch will
turn on underwater lighting. The Storage switch will turn on all
storage spaces, and the Engine Compartment switch will turn
on the engine compartment courtesy lights. Toggle the switches
again to turn them off.
If equipped with RGB lighting, use the color slider bar at the
bottom of the screen to change the color of the lights. Accent
and Courtesy lights are linked together and will always remain
the same color as each other. The underwater RGB light can be
a different color than the Accent and Courtesy lighting. To adjust
the RGB hues separately, tap the RGB button to the left of the
Accent, Courtesy, or Underwater switches. Adjust each set of
lights by sliding the custom RGB bar to the desired color.
To adjust the brightness of the lights, use the Brightness slider
bar located below the RGB slider bar. Tap and drag your finger
along the bar to change the level of brightness.
The hard top brightness can be adjusted separately by tapping
the sun button to the left of the Hard Top toggle button. Adjust
the hard top brightness as desired.