properly maintained. For best results, oil the wood and allow
it to dry before the first use. If the boat sits uncovered in the
sun, teak accent pieces may need to be oiled more often than
they would if the boat was covered and protected from the
sun. The boat should be covered when not in use or when
stored for the winter.
Oiling The Teak
The teak accent pieces will need more frequent maintenance if
they are regularly exposed to direct sun or water. In most cases,
the teak will require maintenance when it gets a dry frosted
look, or when it quits easily shedding water. Teak that gets a lot
of sun and water may need oil 1-2 times a month for the first
year. If the wood starts to get a tacky or gummy feel, oiling may
be too frequent and the wood should be oiled less often.
To oil the teak:
Before Oiling the teak accent pieces you will need teak, tung or
linseed oil which can be found at marinas, paint stores or home
improvement stores.
1. Before applying teak, tung or linseed oil to seal and
protect it, the wood should be cleaned with a mild soap
and water mixture. Harsher cleaners can damage and strip
the wood’s finish.
Platforms
Fiberglass Swim Platform
The fiberglass swim platform requires the same kind of
regular—and gentle—cleaning that the rest of the boat needs.
After cleaning off any environmental debris, wash with mild
soap and warm water. Avoid the use of ArmorAll or similar types
of rubber-shine products as these will speed the decay of the
rubber rather than protect it.
Teak Maintenance
All Wood Accents
To maintain its original appearance and finish, teak wood will
need regular cleaning and oiling. Unprotected wood will turn
gray and could split or separate. If this happens, it may void
the warranty.
New wood accent pieces have been sealed and finished with
an oil-based, wood preservative by the manufacturer. Teak
accent pieces will keep a new look and last for many years if
To Next Page
Loading...
