2021 OWNERS MANUAL / 214
Models
All
Purpose
The key is for safety and security. The key should be inserted
prior to starting an outing, and removed at the conclusion. This is
intended to prevent theft or unapproved use of the boat.
Boats are equipped with an ignition key, which must be inserted
in the ignition key slot and used to activate the boat’s electrical
system. This, in turn, will allow the boat to be started and operated.
The key will be in one of two (2) positions:
• OFF
• ON (electrical power is ON)
Location
The ignition key slot is located on the dash or driver’s arm rest.
Operation
Insert the key into the key slot. Turn the key ON. Never start the
engine without having first run the blower for at least four (4) minutes.
Never leave the ignition switch in the ON position without the
engine running, as this will cause the battery to discharge.
Troubleshooting
If the key will not turn after being inserted in the key slot, it is likely to
be the wrong key.
If the key turns but no electrical power occurs, check the
voltmeter for a reading. If it is lower than 10.5 volts or does
not register, the battery(ies) require recharging. Use only a
MasterCraft battery charger.
DO NOT attempt to jump start the battery from a vehicle or another
boat as this can cause an overload of the boat’s electrical system,
resulting in significant damage to the boat that is not covered
under the warranty.
Attempting to jump start a battery or batteries on a MasterCraft
boat, regardless of battery brand, from a vehicle or another boat
can cause an overload to the boat’s electrical system, resulting
in significant damage to the electrical system. This is not covered
under warranty.
2021MCOwnerManualFINAL.indd 214 8/26/20 1:52 PM
To Next Page
Loading...
Need help?
General
