Step 5
Thoroughly clean and apply a light coat of waterproof marine multi-
purpose grease to the splined area of the shaft and propeller.
Step 6
Align the splines and carefully install the propeller onto the shaft.
DO NOT FORCE THE PROPELLER INTO PLACE. If necessary, gently
tap the propeller into place with a rubber mallet.
Step 7
Install the propeller nut and tighten it into place to 50-ft-lbs with a
torque wrench.
Step 8
Install a new cotter pin and bend the ends around the shaft to lock
the propeller on the shaft.
2021MCOwnerManualFINAL.indd 391 8/26/20 1:54 PM
To Next Page
Loading...
