2023 OWNER’S MANUAL
/
182
may also result in the need to run or anchor with the lights on.
When circumstances require the operation of your MasterCraft
boat at night or in limited visibility, activate the navigation lights,
ensure that they are functioning and SLOW DOWN. Maintain a
close watch for the navigation lights of other vessels and objects
in the water. Failure to do so may result in serious injury. See the
Visual Assistance section of the Boat Operations chapter.
Underwater lights
This two-position toggle switch is pushed UP to turn ON, and
DOWN to turn OFF.
Courtesy lights
This two-position toggle switch is pushed UP to turn ON, and
DOWN to turn OFF.
Failure to leave the bilge pump switches in AUTOMATIC mode can
result in damage to the bilge pumps. The pumps will not shut OFF
while in the MANUAL mode until the operator turns them OFF. Such
damage is not covered under warranty. Malfunctioning pumps or
pumps that do not work at all can result in excess water in the bilge,
and eventually into the deck. Over time, this could result in sinking
of the boat. Such damage is not covered under warranty.
Navigation/Anchor lights
Push the toggle switch UP to turn the lights ON.
• Return the toggle switch to CENTER (neutral) to turn the light OFF.
• Push the toggle switch DOWN to turn the anchor lights ON.
MasterCraft boats are designed for activities that should be
conducted during daylight with good visibility. When operating at
night or in limited visibility, turn on the navigation lights and
slow down.
In limited visibility it is difficult to see and interpret the running
lights of other boats, particularly with lights on-shore that are in the
background. Operating at slower speeds gives you the opportunity
to see and be seen by others. Weather conditions during daylight
Video Screen and
Ballast/Tab Switches
The ballast tanks are filled and
emptied by pressing the switches,
which are clearly marked by tank
designation above the three-
position switches. To fill, press the
appropriate switch UP; to empty,
press the appropriate switch DOWN.
The center (or neutral) position is
OFF and the pumps are inactive.
To Next Page
Loading...
