2023 OWNER’S MANUAL
/
220
automobile rear-view mirror. The billet panoramic mirror
functions dierently than other mirror options. It uses two
locking mechanisms to lock the position of the mirror. To lock in
place, turn the lock knob to the marked lock position, the release
button will pop out. To unlock, push the black release button and
the lock knob will spring open. Raise or lower the mirror, and re-
lock it in place.
Each operator should adjust the mirror to a comfortable viewing
angle based on his or her height for maximum visibility.
Special Attention
MasterCraft recommends boat owners and operators use
only MasterCraft installed mirrors. While there are a number
of third-party mirrors available through marine retailers, the
mirror provided by MasterCraft was selected and developed to
maximize the range of vision for the driver of MasterCraft boats.
If it becomes necessary to replace a mirror, use only MasterCraft
approved mirrors.
Troubleshooting
If a mirror does not stay in place after it has been adjusted to the
driver’s comfort, verify that the hardware holding the mirror in
place is secure. If the driver’s vision is obscured, be certain that
the mirror is clean. Fingerprints, sun tan oil and a host of other
products often used in boats can cause the mirror’s surface to
become dirty, which can negatively aect the driver’s vision when
using the mirror. Clean mirrors properly, as described in the Care
and Maintenance section of this Owner’s Manual.
Prior to operation of the boat, verify that the mirror hardware is
secure. Failure to do so may result in the mirror detaching from
the windshield extrusion. The mirror could hit the operator or a
passenger, resulting in injury.
To Next Page
Loading...
Need help?
General
