Inspect the Fuel System for Leaks
This function should be performed prior to starting the
engine; and then again after about three (3)-to-ve (5)
minutes to determine whether any leaks are apparent.
Step 1: First ensure that the engine is OFF and that the
engine safety starting switch is disconnected. Be certain
that the throttle/shift control lever is in neutral. The
engine must be cool.
Gasoline is highly flammable and its vapors may
ignite, resulting in fire or explosion. Be sure to
keep all sparks and flames away from the area
while inspecting the boat’s fuel system.
Step 2: Open the engine compartment and visually check
as much of the fuel system from the tank to the engine as
you can see. If the odor of gasoline is strong or if you see
visual evidence of fuel outside the system, cease all op-
erations and take the boat immediately to an authorized
MasterCraft dealer’s service department to determine
the source of the leak. The leak must be repaired before
the engine is restarted. Because the lines on late model
MasterCraft boats are pressurized, they can be discon-
nected and/or removed ONLY by using specialized tools
that are not available to the public.
e engine box serves as a machinery guard. e
engine must be OFF whenever the box is open.
Clothing for body parts can get caught in moving
parts, causing death or serious injury. Keep away
from moving parts!
Step 3: After three (3) to ve (5) minutes of operation,
shut down the engine again and ensure that the engine
safety starting switch is disconnected. Be certain that the
throttle/shift control lever is in neutral. Again, inspect
the fuel system as well as possible. If the odor of gasoline
is strong or if you see visual evidence of fuel outside the
system, cease all operations and take the boat immedi-
ately to an authorized MasterCraft dealer’s service depart-
ment to determine the source of the leak. The leak must be
repaired before the engine is restarted. Because the lines
on late model MasterCraft boats are pressurized, they can
be disconnected and/or removed ONLY by using special-
ized tools that are not available to the public.
This is important! Fuel leakage can lead to a build-
up of potentially explosive fumes within the engine
compartment. DO NOT IGNORE OR OVERLOOK
THIS INSPECTION AND REPAIR AS NECESSARY!
Inspect the Exhaust System for Leaks
This function should be performed prior to starting the
engine; and then again after about three (3) to ve (5)
minutes to determine whether any leaks are apparent.
Step 1: First ensure that the engine is OFF and that the
engine safety starting switch is disconnected. Be certain
that the throttle/shift control lever is in neutral. The
engine must be cool.
2008 MasterCraft Owners Manual Page 15-3
To Next Page
Loading...
Need help?
General
