2023 OWNER’S MANUAL
/
156
If an operator has inaccurately or mistakenly entered the fuel level,
there is a sensor in the fuel tank that will override the entered fuel
level when it senses low fuel. To avoid false readings, the sensor
will only override the fuel management system when it detects a
low fuel level for more than 30 seconds with the engine operating
at less than 900 RPM.
To ENABLE or DISABLE the fuel management software:
• Navigate to the Main Menu tab and tap SYSTEM SETTINGS.
• On the system settings page, select either ENABLE or DISABLE
under Fuel Management.
Disabling the fuel management software will allow the fuel gauge
to read fuel levels directly from the sensor on the fuel tank.
You must reset the sensor when disabling fuel management. To
do this, cycle the battery switch ON then OFF. With the key switch
OFF, fill the fuel tank to 100 percent full at a fueling station. Turn
the battery switch ON, then turn the key switch back ON.
When low fuel warning is displayed immediately empty all ballast
tanks and proceed to the nearest fueling station or dock.
To Next Page
Loading...
