EasyManua.ls Logo

MasterCraft X22 2023

MasterCraft X22 2023
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2023 OWNER’S MANUAL
/
426
MasterCraft oers the Ramp-N-Clamp system to simplify loading
and launching the boat from the trailer. To operate:
1. Set the Ramp-N-Clamp handle to the down position so it can catch
the boat when loading onto the trailer.
2. Lift the Ramp-N-Clamp handle to the up position to release boat
from the trailer.
3. Do not lift the Ramp-N-Clamp handle until you are ready to release
boat from the trailer.
Helpful Tips
For easier release on the ramp, put the boat in forward gear or
keep the winch strap tight while lifting the Ramp-N-Clamp handle.
Keeping the Ramp-N-Clamp cover and front of the boat waxed is
part of the proper, regular maintenance.
If the boat rocks back and forth on the trailer while towing, raise
the winch post uprights or add tie down straps to the trailer to
prevent rocking. An ill-fitting trailer will cause wear that is not
covered under the warranty.
A winch strap must be used and firmly tight while towing.
This prevents wear to the bow eye that is not covered under
warranty. Also, it is very important to be sure that the transom of
the MasterCraft boat is resting fully and securely on the supports
provided at the rear end of the trailer, and that it remains in place
when the trailer is parked or underway.
Failure to engage the locking pin may result in the collapse of the
jack stand, which could cause serious injury or death.
Always be certain that the feet of individuals operating the trailer
jack or in the vicinity of the trailer jack are clear when the jack
is lowered into position. A considerable amount of the trailer’s
weight, and that of the boat when it is aboard the trailer, can be
transferred through the trailer jack. This could cause very painful
injuries if feet are not clear of the jack when it is lowered. Be
certain that fingers and hands are clear when moving the trailer
jack because they can be pinched in the mechanism, again
resulting in injury.
Tie Downs
Ensuring that a MasterCraft
boat will be held securely
in place on the trailer’s hull
support (bunks), especially
when towing, is extremely
important. If the boat is not
firmly and properly secured,
the boat can be damaged as it
bounces against the
hull supports.

Related product manuals