2021 OWNERS MANUAL / 250
Care must be taken to ensure that there is always sucient
clearance around the attitude adjustment plate, whether it is in
the water or out, particularly on a trailer. The attitude adjustment
plate(s) extends beyond the boat transom and is not foldable or
retractable. Damage to the plate(s) from failure to allow sucient
clearance is not covered under warranty.
Troubleshooting
• If the switch(es) is/are unresponsive, check the main circuit
break panel to determine if the circuit has tripped. Reset the
circuit and try the switch again.
• If the circuit continues to trip, bring the boat to an authorized
MasterCraft dealer for repair.
If the boat does not respond as noted in the above instructions, turn
OFF the switch and do not use the attitude adjustment function
until the system has been checked by authorized MasterCraft
dealer. Malfunction can result in loss of control of the boat.
Additional Special Attention
DO NOT use the attitude adjustment plate(s) to board the boat. The
edges are sharp and can easily slice through skin. The plate(s) is also
not sturdy enough to withstand many people’s body weight. Damage
to the plate(s) in this manner is not covered under warranty. Use only
boarding ladders and swim platforms to board from the transom side
when boats are equipped with an attitude adjustment plate(s).
Never use the attitude adjustment plate(s) to board or assist
in boarding the boat. Sharp edges can cut individuals, causing
potentially serious bleeding. Damage to the plate(s) from people
using it to board the boat is not covered under warranty.
Additional Special Attention
Care should also be taken when backing up the boat in shallow water,
removing boats from the water on steeply pitched access areas, or
backing up with the boat on a trailer. The attitude adjustment plate(s)
does not fold or retract, and it may require additional clearance to
avoid damage to the plate(s). Resulting damage from failure to follow
instructions is not covered under warranty.
2021MCOwnerManualFINAL.indd 250 8/26/20 1:53 PM