To Next Page

To Previous Page

Step 5

Thoroughly clean and apply a light coat of waterproof marine multi-

purpose grease to the splined area of the shaft and propeller.

Step 6

Align the splines and carefully install the propeller onto the shaft.

DO NOT FORCE THE PROPELLER INTO PLACE. If necessary, gently

tap the propeller into place with a rubber mallet.

Step 7

Install the propeller nut and tighten it into place to 50-ft-lbs with a

torque wrench.

Step 8

Install a new cotter pin and bend the ends around the shaft to lock

the propeller on the shaft.

2021MCOwnerManualFINAL.indd 391 8/26/20 1:54 PM

MasterCraft XT20 User Manual

Questions and Answers: