2021 OWNERS MANUAL / 262
regular cleaning and oiling. Unprotected wood will turn gray and
could split or separate. If this happens, it may void the warranty.
New wood platforms have been sealed and finished with an oil-
based, wood preservative by the manufacturer. Platforms will keep
a new look and last for many years if properly maintained. For best
results oil the platform and allow it to dry before the first use. If
the boat spends a lot of long weekends on the lake with the swim
platform in the water, or if the platform sits uncovered in the sun,
it will need to be oiled more often. The platform should be covered
when not in use or when stored for the winter.
Oiling The Teak Platform
The teak platform will need more frequent maintenance if it is
regularly exposed to direct sun or water. In most cases, the platform
will require maintenance when it gets a dry frosted look, or when
it quits easily shedding water. A platform that gets a lot of sun
and water may need oil 1-2 times a month for the first year. If the
platform starts to get a tacky or gummy feel, oiling may be too
frequent and the platform should be oiled less often.
To oil the platform:
Before Oiling the platform you will need teak, tung or linseed oil which
can be found at marinas, paint stores or home improvement stores.
1. Before applying teak, tung or linseed oil to seal and protect
the platform, the wood should be cleaned and with a mild soap
and water mixture. Harsher cleaners can damage and strip the
wood’s finish.
2. Use a sti bristled brush or rag to clean away dirt and stains.
After cleaning, pat the platform as dry as possible with a clean
towel, then let the platform air dry.
3. Use a cloth or brush to saturate the platform with teak, tung or
linseed oil (front, back and edges). Push the oil into all cracks,
crevices and end grain.
4. Let the platform dry in the shade for 30-45 minutes. After the
platform has had time to soak in fresh oil, use a soft cloth to gen-
tly bu o all excess oil that does not soak into the platform.
2021MCOwnerManualFINAL.indd 262 8/26/20 1:53 PM