lift in the stern and allowing the bow to rise. If the plate is deployed,
the bow may dig.
Shallow Water/Hole Shot: Lower the plate completely by pressing
DOWN. This provides lift in the stern of the boat and will keep the
bow down. As you throttle up and speed increases, raise the tab by
pressing UP.
Uneven Load: If one side of the boat is higher than the other while
running, press DOWN on the switch on that side. This will lower the
tab on the listing side (low side) to bring the boat level.
Porpoising: To stop porpoising, press DOWN. The plate needs only
to be deployed slightly to correct this adverse situation.
While operating attitude adjustment plates use caution. Improper
use of plates can cause accidents, which may result in serious
injury or death. While the boat is underway do not move one plate
up or down significantly as this may cause listing. While at higher
speeds do not over-trim, as this will cause the bow to lower quickly,
resulting in a reduction of speed and may cause the boat to veer.
When in following seas or when running an inlet, the plates should
be fully retracted. This will allow for optimal performance.
ELECTROMECHANICAL ACTUATORS PROVIDE AN INSTANT
RESPONSE. WHEN MAKING ADJUSTMENTS, USE SHORT
MOMENTARY TAPS OF THE SWITCH.
2021MCOwnerManualFINAL.indd 189 8/26/20 1:52 PM
To Next Page
Loading...
Need help?
General
