3. Bluetooth/2.4G/Wired Pairing/Software:
2.4G Pairing:switch the backside button to right(Left button),After the keyboard is turned on,Press
Fn+R to enter 2.4G mode.at this time,the R flash slowly,Long press Fn+R for 3seconds to enter Pairing
mode.the R flash quickly,plug the receiver now.after pairing success,The R will stop flashing.
After 30seconds not finding the paired device,The R indicator will turn off,keyboard will go back to sleep
mode.so you can try again and connect.
(Since 2.4G communication is easily affected by wifi and bluetooth frequency,if connection failed for
the first time,try temporarily turn off the wifi and bluetooth at home, reset the keyboard(Fn+esc for
3seconds),then continue to connect.once the connection succeed,it will basically not failed again.)
Bluetooth pairing:
switch the backside button to left(Left button),After the keyboard is turned on,Press
Fn+Q/W/E to enter bluetooth mode.at this time,the Q/W/E flash slowly,Long press Fn+Q/W/E for 3seconds
to enter Pairing mode.the Q/W/E flash quickly,open your computer bluetooth and searching,once keyboard
show up,connect the keyboard.after pairing success,The Q/W/W will stop flashing.
Wired connection:turn off the keyboard and plug type-c cable.press Fn+TAB enter wired mode.
4. About driver:
You can visit http://www.mathewkb.com and get correct driver according to your requirements.
5. Battery Status:
You can press Fn+backspace to check the battery percentage, 1-0 means 10%-100% percentage.when battery
is low, Fn key will be flashing in red light. Dont charge keyboard by adapter, it will burn the chip,please
charge keyboard directly by you computer or laptop
6. Keymap Demo:https://youtu.be/Otl7CwXOhFY
7. FAQ:
①Q: Why is the keyboard unresponsive when the cable is not plugged in?
A: Confirm whether the on/off button is turned on, whether the mode switch is turned to the right position,
and whether the keyboard has power (refer to the power query for details)
②Q: Why is the keyboard still unresponsive when the cable is plugged in?
A: Confirm whether the cable is plugged in tightly, whether it is switched to wired mode, or the
corresponding wireless mode
③Q: Why is the red light flashing or always on under the FN of the keyboard?
A: The flashing red light of FN means that the keyboard is low on power and needs to be charged. The red
light is charging, and the corresponding backlight mode will be restored after it is fully charged
④Q: How to charge the keyboard?
A: You can use the cable to charge and use it on the computer.
To Next Page
Loading...