INSTALLATION
II The refrigeration system operates most efficiently when installedin an area
with cool, dry air circulation.
_
■
There must be at least 6 inches of clearance on both sides and the back of
the cabinet.
II Select a location away form the heat and moisture generating equipment
such as stoves, ovens, etc.
■
Avoid direct sun rays.
■
Be sure that the floor where you intend to install the unit is strong and level
enough to support the total weight of the unit and its contents.
■
To minimize shock and fire hazards, be sure that the unit is properly
grounded. For your safety and protection, all units are equipped with a
special three-prong grounding plug on the service cord.
■
All units are designed for indoor use. Outdoor use may cause significant
damage to the unit.
PRECAUTIONS
■
To minimize shock and fire hazards, be sure not to overload the outlet.
■
To minimize electric shock and malfunction, do not spray the unit with
water.
■
To minimize fire hazards, do not use flammable spray products near the
unit.
■
After unplugging the unit, wait at least 6 minutes before re-plugging it. It
may cause compressor failure if plugged in before 6 minutes waiting
period.
■
Cautions for cleaning:
*
Unplug the power cord before cleaning.
*
Do not unplug/plug the power cord with wet hands.
*
Do not use an abrasive cleaners, solvents or polishing agents on plastic
parts. Doing so might cause cracking or discoloring.
?
To Next Page
Loading...