To Next PageTo Next Page
Need help?Do you have a question about the Matrix EDH-1560-11 and is the answer not in the manual?
General| Brand | Matrix |
|---|---|
| Model | EDH-1560-11 |
| Category | Power Hammer |
| Language | English |
Ensuring a clean, well-lit workspace and avoiding explosive environments.
Precautions for electrical safety, including plug compatibility and avoiding grounded surfaces.
Maintaining alertness, consciousness, and wearing personal protective equipment (PPE).
Wear ear protection and use additional handles for safe operation.
Details on the intended heavy-duty demolition and chiseling use and restrictions.
Checks before connecting to mains supply, including cable/pipe detection.
Instructions on using and positioning the additional handle for stability.
Steps for inserting SDS MAX chisel, including chuck lock operation.
Procedure for removing the tool, following reverse steps.
Important safety note about holding the tool by both handles and switching on/off.
Instructions on how to switch the demolition hammer on and off.
General advice for using the tool effectively.
Importance of using sharp chisels for good results and long service life.
Procedure for replacing a damaged power cable by authorized personnel.
Specific steps for cleaning air vents, motor housing, and the exterior.
Guidance on checking carbon brushes for excessive sparking, requiring a qualified electrician.
Instructions for lubricating mechanical parts after approximately 50 hours of operation.
Information required when ordering replacement parts, including type and article number.
