304 Matrix ETERNITY NE System Manual
• this List contains the names of clients along with their corresponding account codes, arranged
alphabetically.
• the extension user scrolls through the list to make a selection.
• the number is dialed out.
• Account Codes are applicable for external calls only.
• To use Account Codes, extensions must be allowed this feature in their Class of Service (CoS).
• If you want to use Account Names, you must configure the Account Name List.
• When the Forced Account Code is enabled on a trunk, the system will ask the extension user to enter
the account code irrespective of the method of dialing, whether Global Abbreviated dialing, Personal
abbreviated dialing, Least Cost Routing, or Selective Trunk Access.
• However, if Forced Account Code is enabled on the selected trunk, and the number is dialed using
Selective Trunk Access, the system will dial out the number using Store and Forward dialing.
In the case of Abbreviated Dialing or Direct Dialing, if the extension user fails to dial the Account Code,
an error message will be displayed on the extension user's DKP.
How to configure
For Account Code to work, the System Engineer must:
1. Enable 'Account Codes' feature in the Class of Service (CoS) of the extension(s) to which this feature is to
be allowed.
2. Prepare and configure the Account Name List, if you are going to assign names to the account codes.
3. If Forced Account Code is to be used, enable 'Forced Account Code' flag on the trunks through which calls
using account codes are to be made.
Preparing Account Name List
In consultation with the User, the System Engineer may
• Draw a two-column table on a paper.
• Write Account Codes on one column. Account codes may be any three-digit number between 001 and
999.
• Write the Account Names, i.e., names of the clients on the second column, against their respective
Account Codes.
To Next Page
Loading...
