Matrix ETERNITY NE System Manual 31
Connecting Digital Key Phones
ETERNITY NE supports 2 DKP ports, DKP1 and DKP2. You may connect EON48, EONSOFT; or you may connect
EON48 on one port and DSS64, the DSS Console, on the other port.
EONSOFT has two-PC based DSS Consoles that do not consume any physical DKP Port. So, you may use the
DKP ports as follows:
• On DKP 1 connect EONSOFT and use DSS1 and DSS1
• On DKP 2 connect EON48 or another EONSOFT with DSS1 and DSS2.
1. Use standard twisted wire pair cables of good quality with RJ11 plugs to connect the DKP(s).
2. Lead and terminate the telephone cables from the DKP ports of ETERNITY NE to the wall jacks at the
desired locations.
Installing EON48
1. Unpack the box and verify the package contents.
2. Mount the phone on a desk or wall at a convenient location.
• To mount EON48 on a wall, detach the Foot Stand on the bottom of the phone, as illustrated below.
• Fix two screws of appropriate diameter on the wall, ensuring that they are aligned with the Keyhole
Slots 1 and 2 of EON48. The screws should protrude from the wall to fit into the Keyhole Slots.
• Now, mount the phone with the screws fitting into the keyhole slots.
To Next Page
Loading...
