Matrix ETERNITY NE - Connecting a DSS Console; Installing EONSOFT

Matrix ETERNITY NE System Manual 33
6. You may adjust the LCD for brightness, contrast and backlight. Refer the topic, “Digital Key Phone-
Operation” for instructions.
Connecting a DSS Console
Once you have installed EON with ETERNITY, installing a DSS Console can be done in a few simple steps, very
much similar to those involved in the installation of EON.
1. Unpack the box and verify the package contents.
2. Place the DSS Console next to the DKP, EON, to which it is to be attached.
3. Plug the RJ11 end of a telephone cable into a DKP port of ETERNITY.
Terminate the other end into a wall jack.
4. Plug the RJ11 end of a second cable into the connector on DSS64. Plug the other end into the wall jack.
Installing EONSOFT
To install EONSOFT, you must have a computer with Windows as the operating system. The EONSOFT is
compatible with the following Operating Systems of Windows:
• Windows 98
• Windows XP
• Windows NT
• Windows 2003
• Windows Vista
1. Unpack the box and verify the package contents.
2. Connect the Handset to the dongle. If using a headset, plug the microphone and the speaker connectors
into the dongle.
3. Connect one end of the Communication cable to the COM port of the dongle. Connect the other end of the
communication cable into the COM port of the computer.