572 Matrix ETERNITY NE System Manual
• For each Calling Party Number, in the Auto Login as field, select the extension you want to allow access
to after the Calling Party Number is authenticated.
• Click Submit button to save your entries.
• You may log out of Jeeves.
How to use
If you are a Remote user, to be able to use DISA, you must know:
• the number of the Trunk on which DISA is enabled and the variant of DISA enabled on this trunk.
• the number of the extension and the user password which you want to access, if using DISA with PIN
Authentication.
• the duration of the DISA related Timers: DISA Idle State and DISA Inactivity Timer, so that you may dial
digits accordingly, without delay.
• the special digits to be dialed during a DISA login session.
Dialing Special Digits
After successful login, you will be required to go on-hook, go off-hook, use 'flash', use 'pause' or dial characters like
A, B, C, D, from your remote device to use the features and facilities of ETERNITY.
However, ETERNITY will not be able to understand the conventional way of dialing 'flash' key or going on-hook with
momentary make/break of loop current. Therefore, ETERNITY supports specific codes, which it can interpret if
these are received during DISA session.
When you are in DISA mode, use the following codes to indicate an activity:
Special Digit/activity Code to be dialed
on-hook #0
off-hook #1
Flash #2
Pause #3
A#4
B#5
C#6
D#7
+#8
To Terminate the DISA #9
###
To Next Page
Loading...
