Matrix ETERNITY NE System Manual 49
Starting Up ETERNITY NE
Power ON
• Connect the power adapter to ETERNITY NE.
• Plug in the power adapter of ETERNITY NE into the power outlet.
• Switch on power supply and wait for the Reset Cycle to complete.
Reset Cycle
• Reset Cycle (Power-ON Self Test) takes about 2 minutes to finish.
• The power LED, PWR, is turned on and remains ON.
• When the system becomes stable after power on, the status LED, STS, blinks Green (1 second ON, 1
second OFF).
• The LEDs of the DSS keys of the Digital Key Phone(s) attached to the system are turned on in a
sequence. The handshaking between DKP and ETERNITY lasts for 5-6 seconds.
• At the end of the Reset Cycle, the default extension numbers loaded by the system, the date and time of
the Real Time Clock of the system will appear on the display of the DKP connected.
• Mobile Ports take about 3 minutes to get registered with the network.
You may now access the web-based programming tool, Jeeves, and configure ETERNITY NE.
To Next Page
Loading...
