Matrix ETERNITY NE - Configuring Service Provider-Based LCR

Matrix ETERNITY NE System Manual 635
• Click the link Time+Number-based link to open the page.
• Enter the values of the Time+Number-based LCR you prepared on the sheet of paper in the appropriate
fields.
• Click Submit to save your settings.
• You may log out or continue.
Configuring Service Provider-based LCR
• In Service Provider-based LCR, whenever a number is dialed out, the system ignores the area code, and
starts checking the numbers in the 'Service Provider-based LCR table' and routes the call according to the
lowest cost trunk configured for that number. For this, you must configure the two parameters Area Code
and Ignore Digit Count in the Area Code Table.
• On a sheet of paper make a table for Service Provider-based LCR.
Index
No.
Number
Area
Code
Ignore
Digit Count
Cost Factor
Preference 1 Preference 2 Preference 3 Preference 4
013080305060102