636 Matrix ETERNITY NE System Manual
• As you can see, the Service Provider-based LCR Table is similar to the Number-based LCR table.
• You can configure as many as 99 different numbers which are stored against Index numbers from 01 to
10.
• The number strings may be the complete telephone number, a truncated phone number or the first digit of
the phone number.
• For each number string that you enter against an Index number, you must also specify the Area Code and
the Ignore Digit Count.
• The Ignore Digit Count is the number of digits in the area code that the system should ignore before
checking the Service Provider-based LCR table. For each area code that you enter, the corresponding
Ignore Digit Count will be the number of digits in the area code. For example, the area code for the number
starting with '3' is 080, which consists of 3 digits. So, the Ignore Digit Count for the number/area code 080
will be 3.
• For each number string and area code that you enter, assign the Trunk of the service provider who offers
the lowest tariff to that number/area code. Refer the table you prepared for assigning Cost Factor to trunks.
• If you have finished entering the number strings, their corresponding area codes and the Ignore Digit
Count, and the preferred trunks, configure Service Provider-based LCR using Jeeves.
Configuring Service Provider-based LCR using Jeeves
• Open Jeeves.
Log in as System Engineer.
• Click the Advanced Settings link.
• To configure Area Code and Ignore Digit Count, click the link Call Cost Calculation.
026022301010204
:: :
99 2 03852 5 01 02 01 02
Index
No.
Number
Area
Code
Ignore
Digit Count
Cost Factor
Preference 1 Preference 2 Preference 3 Preference 4
To Next Page
Loading...
