818 Matrix ETERNITY NE System Manual
• Enter the Current SE password. If you have not changed the default SE password 1234, enter this code.
• Enter the New Password. It may be any combination of 4 digits. Valid digits: 0 to 9.
• Enter the new SE password again to Confirm New Password.
• Click Submit button to save your new password.
• You may log out of Jeeves
Forgot the SE Password?
If you have already changed the default SE-Password (1234) and are unable to recall or locate it, you must restore
the default SE password.
Restoring Default SE Password
Restoring the Default SE Password requires you to change the Jumper Settings on the CPU Card. To do this,
• Remove the top cover of the enclosure.
• Locate and change the position of the Jumper J2 from BC to AB.
• Replace the cover of the enclosure.
• Switch ON the system and wait for 15 seconds.
• Switch OFF the system and remove the enclosure cover.
• Change the Jumper position from AB to the original position BC.
• Replace the enclosure cover.
• Switch ON the system.
The default SE password will be restored to 1234. You can now enter the programming mode by dialing 1#91-
1234 (the default password). You can also change the SE password again using Jeeves or by dialing a
command as described above.
If you change the default SE password (1234) again after you have reset SE Password (by changing the
Jumper on the CPU card to AB position), the system will not store the new password, until you change the
Jumper back to the default BC position. So, make sure that you have recorded the new SE password in a
safe place, from where it can be retrieved. Change the Jumper back to the default BC position.
System Administrator (SA) Password
The SA password too is a 4-digit code, which may be any combination of four digits between 0-9. The default SA
password is 1111, which can be changed from the System Administrator mode of Jeeves.
Changing SA Password using Jeeves
• Log in as System Administrator.
To Next Page
Loading...
