Matrix MTS 2050-216 Duo - Use as a Table Saw

Before cutting
56
KUNDENDIENST
DE
+49 (0) 1806/841090
service@matrix-direct.net
10
36
3. The rotating bench handle
10
also serves as a saw head locking
mechanism. Lock the saw head by
folding the rotating bench handle up
until it locks into place with an audible
and noticeable click.
4. Pull the motor locking mechanism
36
out and turn the motor
30
anticlockwise up to the stop point until
the motor locking mechanism audibly
and noticeably locks into place. The
saw blade is now located in the bottom
position.
5. The saw is now in the transport or basic
position.
Use as a table saw
The saw must be in the basic position in order to use the table saw function.
30
36
1. First move the saw to the basic position
(see chapter “Transport/basic position”).
2. Pull on the motor locking mechanism
36
and turn the motor
30
clockwise up
to the stop point until the motor locking
mechanism audibly and noticeably locks
into place. Then let the motor locking
mechanism lock into place.
17
The saw blade
17
is now visible from
above and the saw can be used as a table
saw.
GB