Use
58
KUNDENDIENST
DE
+49 (0) 1806/841090
service@matrix-direct.net
DE
Use
WARNING!
Risk of injury: Improperly using the saw can cause severe injury. Make sure that
you carefully read through and have understood the safety instructions at the
beginning of the user manual.
• Do not use the machine to cut work pieces that are so small that you can not
securely hold them.
• Always use the clamping device to firmly clamp round work pieces in place.
• Use an additional support for long work pieces (tables, sawbucks etc.) that
would tip off of the machine bench if they are not supported.
• Before you switch on the saw, carry out a dry run of the sawing process to
ensure that no problems occur.
• Before cutting, let the saw blade reach the full speed before you move the
saw head down.
• Use a push stick when cutting small workpieces in bench saw mode to avoid
working with the hands close to the saw blade. Keep the push stick in a handy
place near the saw.
NOTICE!
Risk of damage: Using the saw improperly can damage the saw or the work
piece.
• Check the condition of the saw blade before each use. Do not use any
damaged or deformed saw blades.
• Generally switch the saw on before it comes into contact with the material.
• Slowly lower the saw head so as not to overload the motor and to prevent
the saw blade from catching.
• Apply moderate pressure to saw the work piece.
Using the laser
WARNING!
Risk of injury: Improperly using the saw can cause severe injury.
• Never switch the laser on and off while the saw is running.
To Next Page
Loading...
