Use
59
KUNDENDIENST
service@matrix-direct.net
DE
+49 (0) 1806/841090
DE
The laser beam marks the position of the
saw blade when cutting and enables precise
cutting.
− Use the switch on the battery
compartment to switch the laser on and
o.
Sawing
Conventional sawing
40
15
37
6
7
1. Place the work piece you intend to
cut on the rotating bench
15
and
secure it with the clamping device
40
.
2. Push the ON button
6
to switch
the saw on.
3. Push the release lever for the saw
blade cover
37
.
4. Wait a moment (approx. 2 seconds)
until the saw blade reaches
maximum speed.
5. Slowly push the saw head down to
cut through the work piece.
6. Once you have performed the cut,
push the OFF button
7
and wait
until the saw blade has come to a
stop before you swing the saw head
up.
WARNING!
Risk of injury: A rotating bench, which is not properly locked, can move when
cutting and inflict serious injury.
• Make sure that the rotating bench locking mechanism is properly secured
at all times.
To Next Page
Loading...
