Matrix MTS 2050-216 Duo - Bevel Cuts

Special cuts
61
KUNDENDIENST
service@matrix-direct.net
DE
+49 (0) 1806/841090
11
14
1539
1. Release the rotating bench
locking mechanism
39
.
2. Push the rotating bench release
11
down.
3. Push the rotating bench
15
in
the desired direction. The set
angle is indicated on the rotating
bench angle scale
14
.
4. Secure the rotating bench
locking mechanism again by
turning it tight.
You can then perform the desired
cut.
Bevel cuts
From the normal position (0°), the saw head can be swung up to 45° to the left.
22
23
1. Release the vertical angle
lock
23
.
2. Tilt the saw head to the left to the
desired angle. Refer to the vertical angle
scale
22
in the process.
3. Secure the vertical angle lock by
turning it tight.
At higher vertical angles, the clamping device on the side of the saw may
prevent the saw head from being pushed down. Mount the clamping device
on the right side of the saw if you intend to cut at a high vertical angle as the
saw head is tilted to the left.
GB