Troubleshooting
67
KUNDENDIENST
service@matrix-direct.net
DE
+49 (0) 1806/841090
Troubleshooting
Problem Possible cause Solution
1. The saw
doesn’t start.
The mains plug has not
been inserted in a socket.
Insert the mains plug.
The fuse has triggered. Replace the fuse or switch it
back on (circuit breaker).
2. The saw
power is poor.
The saw blade is dull.
Have the saw blade sharpened
or replace it with a new one.
3. The cuts are
not precise.
The angle settings have
changed.
Readjust the angle (see
chapter
“Adjustments”).
Technical data
Model: MTS 2050-216 Duo
Supply voltage: 220–240 V~ / 50 Hz
Nominal output: 1800 W (S1); 2050 W (S6)
Protection class:
II
Idle speed: 5000 rpm
Weight: 10.6 kg
Dimensions: 475 x 460 mm
Saw blade Ø: 216 mm
Saw blade hole Ø: 30 mm
Saw blade thickness: 2.8 mm
Splitting wedge thickness: 2.5 mm
Dust extractor port Ø: 35 mm
Laser class: 2, λ = 650 nm; P≤1 mW, EN 60825-1:2014
Power supply of the laser: 2× LR03 (AAA) battery, 1.5 V
Dimensions of the upper bench: 380 x 260 mm
Angle adjustment of the rotating
bench:
–45° to +45°
Angle adjustment of the saw head
(mitre saw):
0° to 45°
Article number: 210,100,100
GB
To Next Page
Loading...
