Danger of electrical short, shock, electrocution, or fire
Connect to an electrical outlet that complies with this machine’s ratings (for voltage, frequency, and current)
Never use out of doors or in any location where exposure to water or high humidity may occur. Never touch with wet hands
Never allow any foreign object to get inside never expose to liquid spills
ever place any flammable object nearby, never use a combustible aerosol spray nearby, never use in any location where gases can accumulate
Handle the power cord, plug, and electrical outlet correctly and with care. Never use any article that is damaged
When using an extension cord or power strip, use one that adequately satisfies the machine’s ratings (for voltage, frequency, and current)
Connect to ground
Position so that the power plug is within immediate reach at all times
If sparking, smoke, burning odor, unusual sound, or abnormal operation occurs, immediately unplug the power cord, never use if any component is
damaged
Do not use the supplied power supply cord for other products
SITE PREPARATION GUIDE
OPERATING POWER REQUIREMENTS
Delta (USA/Canada) Configuration Wye (European) Configuration:
Voltage 110VAC 1 Phase 220VAC 1 Phase
Frequency 50 to 60 Hz 50 to 60 Hz
Current 3 Amps maximum steady state 3 Amps maximum steady state.
Circuit breaker 5 Amps 5 Amps
azonprinter.com MATRIX GETTING STARTED
To Next Page
Loading...
Need help?
General