SETTING UP YOUR PRINTER
STEP 6
Ink is now inside system , it is time to make a nozzle check. Nozzle check will show you print head status .
Nozzle check sheet need to be placed directly under the print head
path [ printer does not need to go to print mode to make a nozzle
check ]Once the nozzle check sheet is placed rise the machine up for 2
cm and then lower it down.
Printer will automatically adjust the print head height .
You are ready to make a nozzle check follow the instructions bellow :
IMPORTANT
Feed axis is not important for nozzle check sheet positioning , as long as it stays to the right edge of the table
IMPORTANT
When adjusting the head height make sure that nozzle check sheet is under the table and in range of laser sensors
azonprinter.com MATRIX GETTING STARTED
To Next Page
Loading...
Need help?
General