Matthewseffects.com
@matthewseffects
For additional information go to
DC Jack: takes
a external DC 9v
100ma power supply.
Input Jack:
Plug your
guitar in here.
Output Jack:
Plug your
amp in here
Mass: Controls the
mix from dry to wet
Glow: Controls the
amount of shimmer
or octave
Travel: Controls
the feedback
of the reverb.
External Alt Jack: Takes
a NO (normally open)
switch input to change the
alt state of the Astronomer
Expression jack: This
controls the Travel
on the bottom row.
Alt State: When
the LED is on, the
bottom row of
knobs is active.
When the LED is
off, the top row
of knobs is active
Switch 1: Controls
which algorithm
is active on the
top row of knobs
Switch 2: Controls
which algorithm
is active on
the bottom
row of knobs
Bypass: Turns Pedal on/off.
When Bypass and Alt switch is
held for 10 sec it will change
between tails and bypass mode
Alt Switch: Lets
you change
between the top
row and bottom
row of controls
To Previous Page
Loading...