Maverick Campers Operations Manual 2021
- The internal lights of the camper trailer or permanently installed and permanently wire so there is no need to
connect or disconnect the lights. Each light has a switch to allow independent use of lights in various locations
of around the trailer.
- Only turn on the CIGA and Pump lights when you are planning to use them to save power.
Step 5: Connect and Setup the Awning
- Firstly, unpack the canvas awning from storage and find the awning pole map kept in the camper trailer.
- Set aside all poles used in the process of setting up the awning to make it easy to access them.
- Attach the zip fly of the awning to the zip on the side wall near the roof at the front of the camper.
- Us the fly string/rope to pull the fly along the track to zip the entire awning to the camper trailer to the other
end.
- Install the hook poles into the eyelets located along the 3 to 4 positions along the side wall of the camper. They
may be hidden by a circular piece of canvas.
- These 3 or 4 poles form the roof of the awning.
- Then connect these roof poles to the floor poles (which are easy to identify as they have a rubber black foot)
- Attach spreader poles between the roof poles to create tension and secure the roof.
- Repeat this process until you are left with a roof structure as per below:
To Next Page
Loading...