Spangenberg International B.V. – Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
info@maximaholland.nl - www.maximaholland.com
Troubleshooting
The follow overview will help you understand possible problems. However, only qualified
engineers should attempt to open or repair the machine. Contact your supplier when in doubt.
The appliance does not work.
▪ The appliance is switched off.
▪ The power supply is
interupted.
▪ The voltage is not correct.
▪ Overheat protection is active.
➢ Switch on the appliance.
➢ Check the power supply, plug
in power cable.
➢ Use a compatible power
source.
➢ Let the appliance cool down.
The appliance does not seal
properly.
▪ Wrong size bag/tube.
▪ Wrong material bag/tube.
▪ Incorrect sealing time.
▪ Sealing strip/bar is damaged
▪ Dirty bag/tube.
➢ Make sure bag/tube fits
within sealing parameters.
➢ Use suitable bag/tube.
➢ Adjust sealing time.
➢ Replace part.
➢ Use clean bag/tube.
The appliance is not vacuuming
properly.
▪ Incorrect size bag/tube.
▪ Incorrect type bag/tube.
▪ Vacuum chamber gasket
damaged.
▪ Damaged or dirty bag/tube.
➢ Make sure bag/tube fits
within vacuum chamber
➢ Use micro channel or
embossed channel bag/tube.
➢ Replace part.
➢ Use new bag/tube.
Cleaning and Maintenance
• Maintenance and repairs should only be done by a certified technician.
• Regularly check and clean the appliance, its parts and accessories (if applicable).
• Regularly check the power plug and power cable for damage. If either is damaged do not use the appliance.
Instead, have it repaired by a certified electrical engineer.
• Always switch off and disconnect the power supply before cleaning or maintenance.
• Let the sealing strip cool down before cleaning or maintenance.
• ATTENTION! Never use aggressive cleaning agents, abrasives or petrol based cleaning agents. Some cleaning
agents may leave harmful residues or cause damage to the machine. Use a food safe detergent instead.
• ATTENTION! Do not use any scourer and sharp or pointed objects during cleaning, this may cause damage to
the machine.
• ATTENTION! Never hose down the machine or immerse it in water or any other liquid, instead wipe the
exterior with a damp cloth. Do not use a steamer to clean the appliance
• ATTENTION! Never let the power cable or power plug get wet or damp.
• Remove the dripping tray and clean it. Clean the appliance and vacuum chamber using a damp cloth. Ensure
no liquid is left in the vacuum chamber. Always dry the appliance, parts and accessories after cleaning using
a soft cloth.
• Keep the upper lid of the appliance open when not in use
To Next Page
Loading...
