Maxima M-ICE 45 - Cleaning and Maintenance; Storage

Spangenberg International B.V. – Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
info@spangenberg.nl - www.maximaholland.com
• The storage sensor is
defective.
The compressor is working, but
the machine is not producing ice
cubes or producing inconsistent
ice cubes.
• The cooling system is blocked
or refrigerant leakage.
• De ambient temperature is
too high.
• The temperature of the
appliance is too high.
➢ Check if the cooling system is
working, if not contact the
supplier.
➢ Make sure the ambient
temperature is below 43 °C.
➢ Let the appliance cool down
and restart.
Cleaning and Maintenance
• ATTENTION! Maintenance and repairs should only be done by certified engineers, using original parts and
accessories.
• Regularly check and clean the appliance, its cables, tubes/hoses and accessories (if aplicable).
• Regularly check the plug and power cable for any damage. When the plug or cable is damaged do not use
the machine until the defect is repaired by a certified engineer.
• Always switch off the appliance and disconnect the power supply before cleaning.
• ATTENTION: Never use aggressive cleaning agents or abrasives. Do not use solvents or petrol based cleaning
agents. Cleaning agents may leave harmful residues or cause damage to the machine. Warm, soapy water is
recommended for cleaning.
• Remove any calification using a mixture of water and vinegar
• After cleaning, use a soft cloth to dry the appliance.
• Do not use any scourer and sharp or pointed objects during cleaning, this may cause damage to the
machine.
• Clean the condenser every 2 or 3 months.
• ATTENTION! Never hose down the machine or immerse it in water or any other liquid, instead wipe the
exterior with a damp cloth.
• ATTENTION! Never let the power cable and power plug get wet or damp.
Storage
• Make sure the appliance is cleaned the right way before it is being stored.
• Coil the power cord and put it away.
• Store in a cool and dry place.