Spangenberg International B.V. – Rendementsweg 24P – 3641 SL Mijdrecht – Holland – T. +31 (0) 297 253969 – F. +31 (0) 297 256445
info@spangenberg.nl – www.spangenberg.nl
• Always pull the plug out of the socket when the appliance is not being used and always before
cleaning.
• Warning! As long as the plug is in the socket the appliance is connected to the power source.
• Turn off the appliance and wait until the cutting blade has stopped turning, before pulling the
plug out of the socket.
• Never carry the appliance by the cord. Make sure you carry the appliance with both hands by
its casing.
• Avoid overloading and do not use too much strength while you push the food against the
cutting blade of the appliance.
• Do not use any extra devices that are not supplied along with the appliance.
• The electrical installation must satisfy the applicable national and local regulations.
Preparations before using for the first time
• Check to make sure the appliance is undamaged. In case of any damage, contact your
supplier immediately and do NOT use the appliance.
• Remove all the packing material.
• Warning! Different parts can be sharp and can cause wounds when not used with care.
• Place the appliance in the middle of a steady place and level the appliance.
• Place the appliance with the ‘On/Off’ switch facing to the place where the user will stand.
• Make sure the appliance is not placed next to any sources that radiate heat (for example a
heater, stove or oven).
• Make sure the appliance is placed 10 cm from every other object or walls.
• Position the appliance in such a way that the plug is accessible at all times.
• Clean the accessories and the appliance with luke-warm water and a soft cloth.
• When the knife sharpening tool is missing, then place it on top of the appliance.
• Follow the steps in chapter ‘Operation’.
• Warning! When the appliance exhibits overheating, turn off the appliance and let it cool down,
before you restart it.
Operation
• Plug the appliance into the main socket.
• Control whether the appliance has been assembled in the correct way.
• Control the meat; make sure it is free of bone and tough tendon. Make sure you defrosted the
meat.
• Set the desired cutting thickness by using the switch at the side of the appliance.
• Place the food under the cutting arm.
• Use the ‘On /Off’ switch, which is located on the side of the appliance, to start the appliance.
To Next Page
Loading...
