Maximum Controls MATRIX III MAX 1500 PRO - Opening Direction and ID Plug

Factory Learned Input
Factory Learned Input
Additional Unlearned
Normally Closed Photocells
Closing Direction -
does NOT
Opening Direction -
does NOT
10K Sensing Edges
Bi-Parting Gates NOTE:
sensors to EITHER
Learned Inputs NOTE: NOT
NOT be MONITORED and NOT
Opening Direction
Closing Direction
MAG
LOCK
UL
ENTRAP
MAGLOCK
DELAY
GND
OPEN ONLY NC
OPEN ONLY 10K
PHOTO CLS NC
OPEN/CLS NC
GND
12VDC OUT
GND
GND GND JOG LEFT JOG RIGHT TAMPER IN TAMPER NO COM
CLS ONLY 10K
OPEN/CLS 10K
12VDC OUT
NO
COM
NC
LEFT RIGHT
OFF 2.5 sec
1.5 sec
UL SENSOR N.C.UL SENSOR 10K
entrapment protection wiring
5
Entrapment Protection Device Options and Locations:
Entrapment Area
CLOSING Direction Photocell
IMPORTANT: MUST
Inside
Entrapment Area
OPENING Direction Photocell
IMPORTANT: MUST
Beam Height:
UL 325 2018 Standard
TWO
MUST ONE in EACH
12VDC OUT monitored
7
UL 325 2018 Standard - MAX 1500 PRO/2200 PRO/F18 PRO Matrix III Install Version 7b
)-0/24!.4.#TYPE
SENSINGDEVICES-534
BEPOWEREDBY-ATRIX)))
6$#/54MONITORED
ORTHEYWILL./4BE
-/.)4/2%$
3EEPAGES
FORSPECIFICWIRING