dab+ your car Quick Guide
2
STARTING UP THE SYSTEM
1. Turn on your in-car audio system.
2. Switch the car radio to FM 87.6MHz, which is the same as dab+ your car default FM frequency setting.
3. Turn on the dab+ your car and the screen will show《DABradio》.
4. For the first time, it is necessary to perform a Scan function before using the dab+ your car.
Note: 1. dab+ your car needs to operate with an RDS car radio in order to properly display the
relevant system message of dab+ your car via the in-car radio display.
Dab+ your car will be turned off to stay in sleep mode automatically if there is no any key of the remote
controller being pressed within 4 hours. Pressing any key of the remote controller will revert the system
to the last operation before shut down.
SYSTEM OPERATION
To Scan the DAB/DAB+ Services
There are two Scan types available in the dab+ your car: Quick and Full.
When a Quick scan is performed, the dab+ your car will scan only the part of band III (from channel 10A to
channel 13F) that is utilized in the Denmark. In a Full scan, dab+ your car will scan the entire band III from
channel 5A to channel 13F.
1. Press SCAN and then press ▲ or ▼ to select a desired Scan type.
2. Press ENTER to begin scanning for DAB/DAB+ services in the selected channel range.
Note: 1. During Scan DAB/DAB+ Services, the screen will show《 FFF N 》. FFF represents which channel
is currently being scanned and N indicates how many services have been detected so far.
2. When the Scan DAB/DAB+ Services process is finished, the dab+ your car will revert to playing the last
DAB program. If the DAB Service List is empty before scanning, the dab+ your car will tune in the first
service of the new DAB Service List resulted from this DAB Scan. If the DAB Service List is empty before
scanning, and there are no services detected by DAB Scan, the screen will show《Empty》.
3. When the Scan operation is in process, you can press SCAN at any time to stop Scan function and
revert to listening to the currently selected station. All keys except SCAN are disabled when Scan
DAB/DAB+ Services is in progress
To Listen to the DAB/DAB+ Services
1. Quick Tune: Press I◄◄ or ►►I to quickly move from one page to another in alphabetical order.
2. Step Tune: Press ▲ or ▼ to select the desired DAB/DAB+ service.
3. Press ENTER to start tuning the service selected. If you do not press ENTER within 3 seconds, the
system will revert to the original screen automatically. The screen will show《Tuning》.
Note: 1.When the DAB service you selected is not available, the screen will show《Unavail》.
2.When the signal strength of the DAB service you selected is too weak, the screen will show《PoorSig.》.
To Show the Signal Strength
1. Press ENTER when you are listening to a DAB service, caused the screen to show《Sig xx%》. This
indicates the signal strength in percentage terms of the current service.
2. Press ENTER again to revert to the normal DAB service screen.
To Set User Presets
The dab+ your car provides individual memory settings for up to three Users. Each user can set his/her
own Memory Presets of DAB services and has his/her own Latest Service list based on the listening history
of each User.
1. Press ▼USER▼ to select a particular User.
2. The screen will show 《User 1》,《User 2》and《User 3》in sequence each time you press ▼USER
▼. Stop when the desired User number is displayed. The system will revert to the original station
name screen display after 3 seconds.
Note: The default setting is User 1.
To Next Page
Loading...
Need help?
General
