OPERATION
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
NO ature and/or wind chill data will be displaTE: y "FULL" reset, temperAfter an yed and
stored after ten seconds o min. ed and stored after twPressure data will be display utes.
However, Rate of Change/Pressure will show "HOLD" for 72 minutes following a
"FULL" reset.
Any Individual function's memory can be independently reset.
Mov witch to the right (auto) until that pare the toggle s ticular function is
displayed. Then move the toggle switch to the left (reset) and hold it for
six seconds kly b. y will quicThe displa lank, indicating that the memory
for that function has been reset.
A "FULL" reset may also be done to clear all memories simultaneously
or if an adjustment to the barometer setting is needed. Toggle through Mystics settings until the "Present"
fuction is displayed. vThen mo e the toggle switch to the left (reset) and hold it for six seconds y. The displa
will self-test and enter into the barometer adjustment mode. y the barometer may be reset at thisIf necessar
time b Exit the barometer adjustment mode by adjusting the set scre .w on the backplate y moving the toggle
switch to the right (auto) and releasing it.
When the toggle switch is in the center position Mystic will display the
infor y the function light. All the other functionsmation that is indicated b
data are being recorded and stored.
Moving the toggle s ight (auto) and holding it for at least threewitch to the r
seconds will put Mystic into its Auto sequencing mode Y. ou will see each
function light stay on and that particular information displayed for approximately
four seconds and then mo e to the next function automaticallyv.
If Mystic is Auto sequencing and y n that function off - movou wish to tur e the
toggle s ou can nowitch to the r Yight (auto) and release it. w manually step
through the functions as previously mentioned.
Move the toggle switch at the bottom of the case to the right (auto) and allow it
to return. This manually moves the Mystic through the individual functions. The
illuminated function LED's indicate which function and setting is being displayed.
MYSTIC