11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
PAGE 8
LIFT CYLINDER REPLACEMENT
1.
Raise the open Platform about 20” above
the ground. Place a jack under the Platform
and raise an additional 3” or 4”. Measure the
distance between the Cylinder Pins and
record this distance for later use.
2. Remove the Column Cover from the top
of the Column.
?
COLUMN
COVERS
NOTE:
If your unit was one of the first in
production, it came equipped with an
Extension Tube Assembly (shown
below Left). If so, skip Step 3 and go to
Step 9. If your unit has no Extension
Tube Assembly (shown below Right),
then proceed with Step 3.
EXTENSION
TUBE
VALVE
BLOCK
COIL
NUT
LOCK VALVE
& COIL
3. Remove the Coil Nut from the
Lock Valve & Coil. Slide off the
Coil and unscrew the Valve
Cartridge (screwed into the
Valve Block). Remove the bolts
(if any), that secure the Valve
Block to the Column.
To Next Page
Loading...
