11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
13
STEP 3 - WELD LIFTGATE TO VEHICLE - Continued
MEASURING DISTANCE ABOVE BED
LEVEL AT THE TIP OF FLIPOVER
FIG. 13-1
LEVEL LINE
TIP OF
FLIPOVER
1” MAX.
7. At the tip of the Flipover, measure
distance Flipover is raised above bed
level. Tip of Flipover should be above
level line shown in FIG. 13-1, and up to
1” maximum (FIG. 13-1). If measure-
ment is correct, Liftgate is mounted
correctly. If measurement is incorrect,
check the measurements used for
preparing vehicle in STEP 1, and
if needed, repeat this entire step
(STEP 3).
To Next Page
Loading...
