●True Bypass Switching lets your instrument's signal pass through a non-
electronic bypass line when the effect is disengaged, feeding your amp with
direct, unaltered signal from your instrument.
Low noise mechanical switch is used for effect/normal switching.
●LED to indicate effect/bypass and battery condition for trouble-free
performance.
⑤LEVEL
This controls output level of
effected signal. Typically output
levels of both normal signal and
effected signal should be adjusted
to equal levels.
⑥FOOTSWITCH
Switch for effect on/off. Stepping
on this switch alternately turns
effects on and off.
* Effect turns on when you depress
the switch and effect turns off when
you depress and release the
switch.
⑧DC IN (power input jack)
A jack for connection of external
power supply to effect. Be sure to
use the correct Maxon AC
adaptor.
Turn down amplifier's volume
to the minimum before
connecting AC adaptor to the
product in order not to damage
other connected equipment.
④
TONE
This controls the amount of high
frequencies. Turn it clockwise for
more treble and counterclockwise
for less treble.
⑦LED INDICATOR
This indicates the effect/bypass
status and battery condition. It
lights when plug is inserted to
input jack and effect is on. No LED
light indicates the battery is low or
not installed. In this case replace
the battery.
9
ENGLISH
SD9
To Next Page
Loading...
