⑪ ⑫ ⑬ ⑭ ⑮
9
ENGLISH
ROD881
⑥MODE
Switches between overdrive mode
(OD) and distortion mode (DIST).
⑦EFFECT ON/OFF ⑧EFFECT LED
A switch for effect on/off. Stepping on
this switch alternately turns effects and
EFFECT LED on and off.
⑨BOOST ON/OFF ⑩BOOST LED
A switch to boost the output level.
Stepping on this switch alternately
turns boost and BOOST LED on and
off.
* When the effect is off, the boost
switch turns LED on but doesn’t
boost the output level.
⑪DC IN (power input jack)
A jack for connection of power supply
to effect. Be sure to use the correct
Maxon AC adaptor.
Turn down amplifier’s volume to
the minimum before connecting
AC adaptor to the product in
order not to damage other connected
equipment.
⑫OUTPUT (output jack)
Output jack to connect to input of
amplifier or other effects.
⑬NR ON/OFF
Turing on this switch activates the
noise reduction and NR threshold
volume to cancel unwanted noise
when no or little guitar signal comes
out.
⑭NR THRESHOLD
Controls noise reduction threshold
level. Turn it clockwise for more noise
reduction.
* With this volume turned clockwise
too far, you may loose the pick
attack especially when you play low
output guitars.
⑮INPUT (input jack)
Input jack to connect to the output of
guitar, other effects or related
equipment.
This product has a built-in tube,
so do not subject it to shock or
excessive pressure.
It takes one or two minutes for
the tube to work properly after it’s
powered on.
To Next Page
Loading...
