③TUBE
Controls tube gain. Turn it clockwise for
more gain.
④DRIVE
Controls distortion. Turn it clockwise for
more distortion.
⑤TONE
Controls tone in high-frequency range.
Turn it clockwise to emphasize high
tone. Turn it counterclockwise to cut the
high tone.
⑥LEVEL
Controls output level of effected signal.
Typically output levels of both normal
signal and effected signal should be ad-
justed to equal levels.
⑦FOOTSWITCH
Switch for effect / bypass. Stepping on
this switch alternately turns effects on
and off.
* Effect turns on when you depress the
switch and effect turns off when you
depress and release the switch.
⑧INDICATOR
This indicates the effect / bypass sta-
tus. After AC adaptor is connected, it
lights when effect is on with footswitch.
* Tube heater always slightly lights
when AC adaptor is connected.
⑨DC INPUT (power input jack)
A jack to connect the provided AC
adaptor (AC2009).
Be sure that guitar amplifier is turned
down before connecting/discon-
necting the AC2009 power plug
or DC plug.
* It takes 1 - 2 min. warm-up time for
tube to reach stable temperature for
consistent tone.
5
ENGLISH
TOD9
●TBS (True Bypass Switching) using 4PDT mechanical switch lets your
instrument's signal pass through a non-electronic bypass line when the effect is
disengaged, feeding your amplifier with direct, unaltered signal from your
instrument.
●Employs tube heater inrush current control circuit to extend tube’s life.
●AC adaptor AC2009 can be used worldwide from 100VAC to 240VAC by auto
voltage sensing. Main countries’ safety standard approved. Useful for worldwide
touring musicians.
To Next Page
