7
3. Please choose a location where you intend on installing your Gyre pump,
and clean the area using a razor blade to remove all algae.
4. Make sure the glass or acrylic panel of your aquarium is within the
recommended thickness of 15mm (1/2”). For aquariums with glass or
acrylic panel between 15-20mm (1/2” to 3/4”), you may need to use
the optional reinforcement magnet kit (sold separately).
5. Secure the Gyre Pump as illustrated below.
Adjusting the angle of the Flow Cages
1. Rotate the Flow Cages clockwise or counter-clockwise to adjust the
angle of the water flow.
To Next Page
