Maxspect Jump Series User Manual

9
Turn On/Off the Fixture
Press and hold button A for 6s can turn on/off the fixture. While the fixture is
connected to mobile device in either Router Mode or AP Mode, you can turn it on by
doing any operation on the APP. After the fixture is turned on again or recovered
from power cut, it will be back to the previous working status before it was turned off.
Default Factory Setting
Indicator: Constant on in blue
Connection: Router Mode
Working Mode: Manual Working Mode
Brightness: 100% for all channels
Delete WiFi Connection:
1. Disconnect the power of the fixture.
2. Press and hold button A while reconnecting the power of fixture, then release the
button.
3. Press and hold button A for about 3s, release the button while the indicator turns
to RED，WiFi connection is deleted successfully.
4. Disconnect and reconnect again the power of the fixture.
Clear User Setting:
1. Disconnect the power of the fixture.
2. Press and hold button A while reconnecting the power of the fixture, then release
the button.
3.
Press and hold button B for about 3s, release the button while the indicator turns
to GREEN，user setting is cleared successfully.
4. Disconnect and reconnect again the power of the fixture.
Operating Instructions
1.
Press button B to check if the indicator is strobing in GREEN, if not press and
hold button B for about 6s to change to AP Mode.
2.
Open the WiFi list of mobile device and choose the SSID starts with “MJ-L1B0”,
input the password “123456789”(Unchangeable).
3.
Open the APP, click “Server” on the right top side of the login page and select
“AP Mode”.
4.
While a fixture with an ID starts with “MJ-L1B0”is shown on the list of “
Discovery
of New Devices”, it means that the fixture is connected to your mobile device
successfully.
AP Mode Connection
EN

Maxspect Jump Series Specifications

General

Brand	Maxspect
Model	Jump Series
Category	Aquariums
Language	English