EasyManua.ls Logo

MAXXMEE Face Contour - Operating the Device; Procedure During the Massage (Green Light) and Heat Phase (Red Light); Procedure During the Cold Phase (Blue Light)

MAXXMEE Face Contour
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
16
Operating the Device
1. Switch on the device using the oper-
ating button(9) and set the operating
mode you want:
Press 1 x Massage: green light
+ massage
can help to reduce
skin sagging, swell-
ing and rings under
the eyes
Press 2 x Cold phase:
blue light + cold
(-1°C) + vibration
to stimulate the
breakdown of fat
cells
Press 3 x Heat phase: red light
+ heat (+44°C) +
vibration
to support skin
circulation and the
flushing out of the fat
cells after the cold
phase; can prevent
wrinkles
Press 4 x Off
The device automatically switches
to the next phase after 5 minutes
and switches off after the end of
the heat phase (red light).
2. Depending on which operating mode
is selected, treat the skin as described
below.
Procedure During the Massage
(Green Light) and Heat Phase (Red
Light)
Place the metal plate(12) on the area
which is to be treated and guide it over
the skin in a slow flowing motion. Treat
the individual areas as follows:
Rings under the eyes: Start at the
bridge of the nose and stroke under
the eyes out towards the cheeks.
(Picture F)
Cheeks: Stroke outwards from the
cheekbones. Repeat this process be-
low the cheekbones. (Picture G)
Forehead: Start in the middle of the
forehead at the level of the eyebrows
and move outwards towards your
hairline. (Picture H)
Chin: Start below the bottom lip and
move downwards towards the jaw.
(Picture I)
Jawline: Stroke from the middle of the
chin along the jawline out towards the
ears. (Picture J)
Neck: Short sharp strokes from the
bottom up towards the jaw. (Picture K)
Neckline: Small circular movements
from the inside outwards. (Picture L)
Procedure During the Cold Phase
(Blue Light)
During the cold phase, process the
area to be treated gradually from bot-
tom to top (with a double chin from
the neck to the chin). When you do
this, hold the metal plate in one place
for approx. 1minute, or as long as it is
not too uncomfortable, then move on
to the next place. (Picture M)
After the cold phase, carry out the
heat phase (red light) on the treated
area or gently rub and massage it
06161_Inlay_A5_de-en-fr-nl_V1.indb 16 02.03.2020 18:19:24

Related product manuals